Type 6223 Servo-Assisted 2-Way High-Flow Solenoid Control Valve
Burkert Type 6223 Servo-Assisted 2-Way High-Flow Solenoid Control Valve
The Burkert Type 6223 Proportional Solenoid Valve can be used for the control of larger flow quantities. Low hysteresis, high reproducibility and good response sensitivity guarantee good positioning behaviour. The valve closes tight. The push-over coil is easy to replace.
Key features:
- Control valve for continuous control of liquids
- Low hysteresis and high repeatability
- Control with PWM signal
- Servo-assisted, tight closing valve
- Brass Body
- FKM Seals
- Port Size: G 3/8" to G 1"
- Orifice Size: 10mm to 20mm
- 24V DC
Datasheet:
Burkert Type 6223 Servo-Assisted 2-Way High-Flow Solenoid Control Valve Datasheet
| Process / Industry | N/A |
|---|---|
| Body Material | Brass |
| Design | 2 Way |
| Port Size | 3/8", 1/2", 3/4", 1", G3/8, G1/2, G3/4, G1 |
| Manufacturer | Burkert |
The following downloads are available for the Burkert Type 6223 Servo-Assisted 2-Way High-Flow Solenoid Control Valve:
Burkert Type 6223 Servo-Assisted 2-Way High-Flow Solenoid Control Valve Datasheet
Burkert Type 6223 Servo-Assisted 2-Way High-Flow Solenoid Control Valve Operating Instructions
Burkert Type 6223 Servo-Assisted 2-Way High-Flow Solenoid Control Valve EU Declaration of Conformity
Please check your required flow rate using the table below, prior to ordering your solenoid control valve.
| Port Size | Orifice (mm) | Kvs value (m3/h) | QNn value (I/min) | Pressure Range (Bar) |
| G 3/8" | 10 | 1.4 | 1510 | 0.5 - 10 |
| G 1/2" | 10 | 1.4 | 1510 | 0.5 - 10 |
| G 1/2" | 13 | 2.5 | 2700 | 0.5 - 10 |
| G 3/4" | 13 | 2.5 | 2700 | 0.5 - 10 |
| G 3/4" | 20 | 5.0 | 5400 | 0.5 - 10 |
| G 1" | 20 | 5.0 | 5400 | 0.5 - 10 |
Kvs value: Flow rate value for water, measured at 20°C & 1 bar pressure differential over a fully opened valve.
QNn value: Flow rate value for air with inlet pressure of 6 bar, 1 bar pressure differential and 20°C.
Pressure Range: Overpressure with respect to atmospheric pressure; if the differential pressure over the valve exceeds 5 bar the characteristics may change.
